How to set up your Raspberry Pi to play Atari 2600 games — Engadget

http://www.engadget.com/2012/09/28/how-to-set-up-your-raspberry-pi-to-play-atari-2600-games/

Advertisements

Very cool tut on GPIO with RaspPi in Scratch.

CympleCy (SimpleSi)

This blog is now old hat – I’ve made a new version and much better instructions over in a new blog.

Click here

———————————————————————————-

This post is intended to make it as Simple as Pi to get up and running and make your RaspberryPi control some lights and to respond to switches and sensors.

Minimum Requirements – a RaspberryPi with Raspbian installed and a working internet connection, a breadboard, some Light Emitting Diodes (LEDs), some resistors and some wire connectors. Total cost £5-£10.

How to get a Rapsberry_Pi to control the GPIO Pins from Scratch
—————————————————————
Your RaspberryPi needs to be connected to the internet to install the software but not needed to run ScratchGPIO.

Copy the text below ( left click just before the s of sudo and drag right until all the text in the line, up to and including gpio.sh, as been selected) then right-click and select…

View original post 1,237 more words